Plastics piping systems for the supply of gaseous fuels - Polyethylene (PE) - Part 4: Valves

This document specifies the characteristics of valves made from polyethylene (PE) for piping systems in the field of the supply of gaseous fuels.It is applicable to isolating unidirectional and bi-directional valves with spigot ends or electrofusion sockets intended to be fused with PE pipes or fittings conforming to prEN 1555-2:2024 and prEN 1555-3:2024 respectively.Valves made from materials other than PE, designed for the supply of gaseous fuels conforming to the relevant standards can be used in PE piping systems according to prEN 1555 (all parts), provided that they have PE connections for butt fusion or electrofusion ends, including integrated material transition joints, conforming to prEN 1555-3:2024. It also specifies the test parameters for the test methods referred to in this document. In conjunction with Parts 1, 2, 3 and 5 of EN 1555, it is applicable to PE valves, their joints and to joints with components of PE and other materials intended to be used under the following conditions: a) a maximum operating pressure, MOP, up to and including 10 bar1 at a reference temperature of 20 °C for design purposes; b) an operating temperature between -20 °C to 40 °C. EN 1555 (all parts) covers a range of maximum operating pressures and gives requirements concerning colours. This document covers valve bodies designed for connection with pipes with a nominal outside diameter dn ≤ 400 mm.